Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 155 (DATA COMMUNICATIONS SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC U0002CIRCUIT/SYSTEM TESTING
2013 Buick Regal Turbo Premium, Standard Trans
Circuit/System Testing
2013 Buick Regal Turbo Premium, Standard TransSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- With a scan tool, verify DTC U0100-U02FF or U2105-U2199 is not set as current.
- If DTC is set, refer to DTC U0100-U02FF (without HP6)Β , DTC U0100-U02FF (with HP6)Β , or DTC U2105-U2199Β .
- Ignition OFF, disconnect the applicable control module harness connector.
- Ignition OFF, test for less than 5 Ξ© between the applicable control module ground circuit and ground.
- If greater than the specified range, test the circuit for an open/high resistance.
- Ignition ON, verify a test lamp illuminates between the following circuits of the applicable control module and ground:
- The battery positive voltage input circuits
- The battery positive voltage output circuits
- The ignition voltage input circuits
- The ignition voltage output circuits
- The switched battery positive voltage supply circuits
- If the test lamp does not illuminate, test the circuit for an open/high resistance. If the circuit fuse is open, test the circuit for a short to ground. If the circuit tests normal, replace the applicable control module.
- Ignition OFF, test for less than 5 Ξ© between the non-communicating control module GMLAN serial data circuits and the control module reporting DTC U0002.
- If greater than the specified range, test the circuit for an open/high resistance.
- If all circuits test normal, replace the applicable control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.