Radio and Telephone Control Switch Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Radio and Telephone Control Switch Replacement
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radio & Telephone Control Switch
GM2219059Courtesy of GENERAL MOTORS COMPANY
Radio and Telephone Control Switch Replacement

Callout Component Name
Preliminary ProcedureΒ 
Remove the steering wheel lower cover. Refer to Steering Wheel Spoke Lower Cover Replacement .
1 Steering Wheel Lower Cover Fasteners (Qty: 2)
CAUTION:

Refer to Fastener Caution .

2 Radio and Telephone Control Switch

Procedure

  1. Release all the retainers and disconnect the electrical connector.
  2. Remove the radio and telephone control switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.