Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 150 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD OUTSIDE MOISTURE AND HEADLAMP AUTOMATIC CONTROL AMBIENT LIGHT SENSOR REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans
Windshield Outside Moisture and Headlamp Automatic Control Ambient Light Sensor Replacement
2013 Buick Regal Turbo Premium, Standard TransSECTION Windshield Outside Moisture and Headlamp Automatic Control Ambient Light Sensor Replacement
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Windshield Outside Moisture and Headlamp Automatic Control Ambient Light Sensor Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the inside rearview mirror mount plate cover. Refer to Inside Rearview Mirror Mount Plate Cover Replacement |
|
| 1 | Windshield Outside Moisture and Headlamp Automatic Control Ambient Light Sensor Retainer TIP: Use a small flat-bladed tool to release the locking retainer on the windshield outside moisture and headlamp automatic control ambient light sensor and push the cap upwards. |
| 2 | Windshield Outside Moisture and Headlamp Automatic Control Ambient Light Sensor |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.