SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 150 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSHEADLAMP REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Headlamp Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Headlamp Replacement
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Headlamp
GM2208659Courtesy of GENERAL MOTORS COMPANY
Headlamp Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .
  2. Remove the front bumper fascia support. Refer to Front Bumper Fascia Support Replacement (Right Side) , Front Bumper Fascia Support Replacement (Left Side) .
1 Headlamp Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
2 Headlamp Assembly (W/Front Side Marker and Park and Turn Signal Lamp)
WARNING:

Refer to Halogen Bulb Warning .

Procedure

  1. Pull the headlamp assembly forward in order to access and disconnect the forward lamp harness electrical connector from the headlamp jumper harness connector.
  2. Remove the headlamp bulb accessory covers.
  3. Transfer the headlamp bulbs as needed.
  4. Aim the headlamps after the headlamps have been re-installed. Refer to Headlamp Aiming .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.