SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 150 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE TURN SIGNAL LAMP REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Front Side Turn Signal Lamp Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Front Side Turn Signal Lamp Replacement
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Side Turn Signal Lamp
GM2019763Courtesy of GENERAL MOTORS COMPANY
Front Side Turn Signal Lamp Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the front wheelhouse rear liner. Refer to Front Wheelhouse Rear Liner Replacement .
  2. Disconnect the front side turn signal lamp electrical connector.
  3. Squeeze the lamp housing locking retainer and push outward in order to remove the front side turn signal lamp from the fender panel.
1 Front Side Turn Signal Lamp
TIP:  Replace the bulb, as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.