Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The headlamp high beam relay is supplied with battery voltage at all times. The turn signal/multifunction switch signal circuit is grounded by pressing the turn signal/multifunction switch. The body control module (BCM) energizes the headlamp high beam relay by applying ground to the headlamp high beam relay control circuit. When the headlamp high beam relay is energized, the relay switch contacts close and battery voltage is applied through the high beam lamp fuses to the high beam lamp supply voltage circuit which illuminates the high beam lamps.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.