SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 145 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT LEVEL SENSOR REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Windshield Washer Solvent Level Sensor Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Windshield Washer Solvent Level Sensor Replacement
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Washer Solvent Level Sensor
GM2203352Courtesy of GENERAL MOTORS COMPANY
Windshield Washer Solvent Level Sensor Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the LF wheelhouse liner. Refer to Front Wheelhouse Front Liner Replacement .
  2. Disconnect the windshield washer level sensor electrical connector.
  3. Place a clean suitable drain pan under the level sensor area in order to contain the loss windshield washer solvent.
  4. Use two medium sized flat-bladed tools under the level sensor grommet and pry in opposite directions, disengage the level sensor from the windshield washer container.
  5. Remove and discard the level sensor grommet.
1 Windshield Washer Solvent Container Level Sensor
2 Windshield Washer Solvent Container Level Sensor Grommet
Procedure 
Top off the windshield washer solvent container with new windshield washer solvent.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.