SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 145 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER PUMP REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Windshield Washer Pump Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Windshield Washer Pump Replacement
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Washer Pump
GM2203346Courtesy of GENERAL MOTORS COMPANY
Windshield Washer Pump Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the LF wheelhouse liner. Refer to Front Wheelhouse Front Liner Replacement .
  2. Disconnect the windshield washer pump electrical connector.
  3. Disconnect the windshield washer pump hose from the washer pump spout.
  4. Place a clean suitable drain pan under the washer pump area in order to contain loss windshield washer solvent.
  5. Pull the top of the washer pump outward in order to disengage the top of the washer pump from the windshield washer container.
  6. Use two medium sized flat-bladed tools under the washer pump grommet and pry in opposite, disengage the washer pump from the windshield washer container.
  7. Remove and discard the windshield washer pump and grommet.
1 Windshield Washer Pump Assembly
TIP:  Refill the windshield washer container after the washer pump replacement.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.