SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 119 (AUTOMATIC TRANSMISSION - 6T45 - REPAIR INSTRUCTIONS - OFF VEHICLE)REPAIR INSTRUCTIONS - OFF VEHICLEINPUT, REACTION, AND OUTPUT CARRIER DISASSEMBLE
2013 Buick Regal Turbo Premium, Standard Trans

Input, Reaction, and Output Carrier Disassemble

2013 Buick Regal Turbo Premium, Standard TransSECTION Input, Reaction, and Output Carrier Disassemble
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Disassembled View Of Input, Reaction & Output Carrier
GM1891335Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Output Carrier Assembly
Tip: 
  • The 6T30 and 6T40 have 4 pinions.
  • The 6T45 and 6T50 have 5 pinions.
2 Output Carrier Thrust Bearing Assembly
3 Input Sun Gear Thrust Bearing Assembly
4 Input Carrier Assembly
Tip: 
  • The 6T30 and 6T40 have 4 pinions.
  • The 6T45 and 6T50 have 5 pinions.
5 Input Sun Gear
6 Input Sun Gear Thrust Bearing Assembly
7 Input Carrier Thrust Bearing Assembly
8 Reaction Carrier Assembly
Tip: 
  • The 6T30 and 6T40 have 3 pinions.
  • The 6T45 and 6T50 have 4 pinions.
9 Reaction Carrier Sun Gear Assembly
10 Reaction Carrier Sun Gear Thrust Bearing
Tip:  The sun gear thrust bearing may be stuck to the sun gear.
11 3-5 Reverse and 4-5-6 Clutch Housing Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.