Control Valve Body Cover Installation

2013 Buick Regal Turbo Premium, Standard TransSECTION Control Valve Body Cover Installation
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Valve Body Cover Bolt Tightening Sequence
GM1891447Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Input Speed Sensor Connector
2 Output Speed Sensor Connector
3 Shift Position Switch Connector
4 Control Valve Body Cover Wiring Connector Hole Seal
Tip:Β  Do not re-use the valve body cover wiring connector hole seal.
5 Control Valve Body Cover Gasket
Tip:Β  Do not re-use the valve body cover gasket.
6 Control Valve Body Cover
7 Control Valve Body Cover Bolts M6 x 30 (Qty: 13)
CAUTION: Refer to Fastener Caution .

Tighten:Β  12 N.m (106 lb in)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.