SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 119 (AUTOMATIC TRANSMISSION - 6T45 - REPAIR INSTRUCTIONS - OFF VEHICLE)REPAIR INSTRUCTIONS - OFF VEHICLE3-5-REVERSE AND 4-5-6 CLUTCH HOUSING, AND INPUT, REACTION, AND OUTPUT CARRIER INSTALLATION
2013 Buick Regal Turbo Premium, Standard Trans

3-5-Reverse and 4-5-6 Clutch Housing, and Input, Reaction, and Output Carrier Installation

2013 Buick Regal Turbo Premium, Standard TransSECTION 3-5-Reverse and 4-5-6 Clutch Housing, and Input, Reaction, and Output Carrier Installation
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 3-5-Reverse, 4-5-6 Clutch Housing, Input, Reaction And Output Carrier
GM1891378Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 3-5 Reverse and 4-5-6 Clutch Housing Thrust Bearing
2 2-6 Clutch Apply Plate (Waved)
3 2-6 Clutch Plate (Qty: 1)
Tip: 
  • Only install one 2-6 Clutch Plate. The remaining clutch plate is installed with the gearset assembly.
  • Align the large flat areas with the valve body end of the case and the 2 tabs on the clutch plate that are close to each other with the slots at the bottom right corner of the case.
4 3-5 Reverse and 4-5-6 Clutch Housing Assembly and Gearset
Tip:  Align the large flat areas of the 2-6 Clutch Plate with the valve body end of the case and the 2 tabs on the clutch plate that are close to each other with the slots at the bottom right corner of the case.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.