Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (PROGRAMMING AND SETUP - ALL SYSTEMS)REPAIR INSTRUCTIONSREAR DIFFERENTIAL CLUTCH CONTROL MODULE PROGRAMMING AND SETUPREAR DRIVE CLUTCH CONTROL MODULE REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans
Rear Drive Clutch Control Module Replacement
2013 Buick Regal Turbo Premium, Standard TransSECTION Rear Drive Clutch Control Module Replacement
WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The transfer case solenoid valve and the rear drive clutch control module must always be replaced together due to calibration reasons.
If the rear drive clutch control module needs to be replaced, the following procedures must be performed:
- Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
- Perform the SPS function Rear Differential Clutch Control Module - Programming and follow the on-screen instructions.
- Perform the SPS function Rear Differential Clutch Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both ECU Configuration / Reconfiguration and ECU Setup.
- Clear DTCs after completing the programming procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.