Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - K36 (X2) TO M72COMPONENT CONNECTOR END VIEWSK40 SEAT MEMORY CONTROL MODULE X4 A45/CZ2
2013 Buick Regal Turbo Premium, Standard Trans
K40 Seat Memory Control Module X4 A45/CZ2
2013 Buick Regal Turbo Premium, Standard TransSECTION K40 Seat Memory Control Module X4 A45/CZ2
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool |
|---|---|---|---|
| I | 13575577 | J-35616-35 (VT) | J-38125-553 |
K40 Seat Memory Control Module X4 A45/CZ2
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 1 | RD/D-GN | 240 | Battery Positive Voltage | I | - |
| 2 | 0.35 | BK/BU | 5978 | Memory Switch Low Reference | I | - |
| 3 | 2.5 | BK | 250 | Ground | I | - |
| 4 | - | - | - | Not Occupied | - | - |
| 5 | 2.5 | RD/D-GN | 240 | Battery Positive Voltage | I | - |
| 6 | 1 | BK | 150 | Ground | I | - |
| 7 | 1.5 | L-GN/BN | 286 | Driver Power Seat Front Vertical Motor Up Control | I | - |
| 8 | 1.5 | D-BU/VT | 287 | Driver Power Seat Front Vertical Motor Down Control | I | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.