Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - B59L TO F106RFCOMPONENT CONNECTOR END VIEWSB65 INTAKE MANIFOLD PRESSURE AND AIR TEMPERATURE SENSOR (LDK)
2013 Buick Regal Turbo Premium, Standard Trans
B65 Intake Manifold Pressure and Air Temperature Sensor (LDK)
2013 Buick Regal Turbo Premium, Standard TransSECTION B65 Intake Manifold Pressure and Air Temperature Sensor (LDK)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool |
|---|---|---|---|
| I | 13575415 | J-35616-35 (VT) | J-38125-36 |
B65 Intake Manifold Pressure and Air Temperature Sensor (LDK)
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 0.5 | WH | 7332 | Pre Throttle Air Temp and Press (TMAP) Low Reference | I | - |
| 2 | 0.5 | L-BU | 7329 | Pre-Throttle Air Temp and Press (TMAP) Temperature Signal | I | - |
| 3 | 0.5 | GY | 7331 | Pre Throttle Air Temp and Press (TMAP) 5 Volt Reference | I | - |
| 4 | 0.5 | VT/GY | 7330 | Pre Throttle Air Temp and Press (TMAP) Air Pressure Signal | I | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.