Rear Side Door Stationary Window Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Rear Side Door Stationary Window Replacement
Fig 1: Rear Side Door Window Weatherstrip & Fasteners
GM2019660Courtesy of GENERAL MOTORS COMPANY
Rear Side Door Stationary Window Replacement

Callout Component Name
CAUTION:

Refer to Paint Damage Caution .

Preliminary Procedure Remove the rear side door trim panel. Refer to Rear Side Door Trim Panel Replacement .
1 Rear Side Door Stationary Window Rear Channel Fastener (Qty: 2)
2 Rear Side Door Stationary Window Rear Channel Fastener
CAUTION:

Refer to Fastener Caution .

Procedures

  1. Apply masking tape to the outer applique and frame.
  2. Lower the window.
  3. Remove the rear side door water deflector.

Tighten 
10 N.m (89 lb in)
3 Rear Side Door Stationary Window
NOTE:

When replacing the rear side door window weatherstrip it is necessary to transfer the rear side door stationary window.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.