SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REGULATOR REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Front Side Door Window Regulator Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Front Side Door Window Regulator Replacement
Fig 1: Front Side Door Window Regulator & Fasteners
GM2019719Courtesy of GENERAL MOTORS COMPANY
Front Side Door Window Regulator Replacement

Callout Component Name
WARNING:

Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

Preliminary Procedure Remove the front side door window. Refer to Front Side Door Window Replacement .
1 Front Side Door Window Regulator Fasteners (Qty: 5)
CAUTION:

Refer to Fastener Caution .

Procedures

  1. Remove the water deflector.
  2. Release the 2 window retainers, push the window to the full up position and tape in place.

Tighten 
10 N.m (89 lb in)
2 Front Side Door Window Regulator

Procedures

  1. Disconnect the front side door window regulator electrical connector.
  2. Window regulator motor programming and set-up. Refer to Control Module References .
  3. Inspect the door window for proper operation before installing the door trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.