SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE BRACKET REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Communication Interface Module Bracket Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Communication Interface Module Bracket Replacement
Fig 1: Communication Interface Module Bracket & Fasteners
GM2771825Courtesy of GENERAL MOTORS COMPANY
Communication Interface Module Bracket Replacement

Callout Component Name

Preliminary Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel lower trim panel replacement. Refer to Instrument Panel Lower Trim Panel Replacement - Left Side .
  3. Remove the instrument panel lower extension side trim panel. Refer to Instrument Panel Lower Extension Side Trim Panel Replacement .
  4. Remove the instrument panel lower center trim panel. Refer to Instrument Panel Lower Center Trim Panel Replacement .
1 Communication Interface Module Bracket Fastener (Qty: 2)
CAUTION:

Refer to Fastener Caution .
2 Communication Interface Module Bracket

Procedure

  1. Disconnect electrical connections.
  2. Transfer components, as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.