Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSBUICK2013ENCORE LEATHER, AWDREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALWIRING SYSTEMS AND POWER MANAGEMENT - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSFRONT COMPARTMENT FUSE BLOCK REPLACEMENT
2013 Buick Encore Leather, AWD
Front Compartment Fuse Block Replacement
2013 Buick Encore Leather, AWDSECTION Front Compartment Fuse Block Replacement
Front Compartment Fuse Block Replacement
| Callout | Component Name |
|---|---|
| 1 | Front Compartment Fuse Block Cover Procedure Remove the accessory wiring junction block cover by pushing in on the 3 retainer tabs located on the ends of the cover and lift. To reinstall, fit together the retainer tabs located on the ends of the cover and push down on the cover until the tabs on the ends of the cover lock into place. |
| 2 | Front Compartment Fuse Block Bolt (Qty: 3)
CAUTION:
Refer to Fastener Caution . Tighten 10 (89 lb in) |
| 3 | Front Compartment Fuse Block Fuse Assembly Procedure Disconnect the positive battery cable. |
| 4 | Front Compartment Fuse Block Cover Bracket Nut Tighten 9 (80 lb in) |
| 5 | Front Compartment Fuse Block Procedure Release the front compartment fuse block retainer by pushing in on the 2 retainer tabs located on the front and rear sides of the retainer and lift. To reinstall, fit together the retainer tabs located on the front and rear sides of the retainer and press down on the retainer until the tabs on the sides of the cover lock into place. |
| 6 | Front Compartment Fuse Block Harness Procedure Lift up and out from the fuse block base. |
| 7 | Front Compartment Fuse Block Base Nut Tighten 9 (80 lb in) |
| 8 | Front Compartment Fuse Block Base Procedure
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.