Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pump Flow Control Module Replacement
2011 Buick Enclave CXL, FWDSECTION Fuel Pump Flow Control Module Replacement
Fuel Pump Flow Control Module Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle . |
|
| 1 | Fuel Pump Flow Control Module Fastener (Qty: 3)
CAUTION:
Refer to Fastener Caution TIP: The bolts used are two headed and can be loosened from the module side, then maneuvered out of the slots. Tighten 9 N.m (80 lb in) |
| 2 | Fuel Pump Flow Control Module Procedure
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.