Accessory AC and DC Power Control Module Replacement

2011 Buick Enclave CXL, FWDSECTION Accessory AC and DC Power Control Module Replacement
Fig 1: Accessory AC & DC Power Control Module
GM2730490Courtesy of GENERAL MOTORS CORP.
Accessory AC and DC Power Control Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the quarter lower rear trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Acadia with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB5) , Quarter Lower Rear Trim Panel Replacement (Acadia with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB4) .
1 Accessory AC/DC Power Control Module Assembly

Procedure

  1. Disconnect the electrical connections.
  2. Remove the jack assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.