Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programming Procedure
2011 Buick Enclave CXL, FWDSECTION Programming Procedure
- Install a scan tool.
- Navigate to the Body menu item.
- Select the appropriate (Driver or Passenger) Door Switch menu item.
- Select Special Functions.
- Select Power Window Motor Programming and follow the directions displayed on the screen.
- When the window motor programming procedure has been successfully completed, remove the PWR WNDW circuit breaker from the I/P fuse block for at least 30 seconds.
- Install the PWR WNDW circuit breaker.
- Press and hold the power window switch until the window is fully DOWN.
- Continue holding the power window switch for approximately 3 seconds.
- Press and hold the power window switch until the window is fully UP.
- Continue holding the power window switch for approximately 3 seconds.
- The power window regulator motor is now programmed for the express function.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.