SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2011ENCLAVE CXL, FWDREPAIR AND DIAGNOSISBODY & FRAMEFIXED AND MOVEABLE WINDOWSREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW UPPER REVEAL MOLDING REPLACEMENT
2011 Buick Enclave CXL, FWD

Rear Side Door Window Upper Reveal Molding Replacement

2011 Buick Enclave CXL, FWDSECTION Rear Side Door Window Upper Reveal Molding Replacement
Fig 1: Identifying Rear Side Door Window Reveal Molding
GM1843272Courtesy of GENERAL MOTORS CORP.
Rear Side Door Window Upper Reveal Molding Replacement

Callous Component Name
1 Rear Side Door Window Upper Reveal Molding Lower Screw
CAUTION:

Refer to Fastener Caution .


Procedure 
The screw is located in the front lower door frame.
Tighten 
5 N.m (44 lb in)
2 Rear Side Door Window Upper Reveal Molding Upper Screw
Procedure 
The screw is located in the upper rear corner of the door frame.
TIP:  Replace the clip if damaged, transfer the clip to the new part.
3 Rear Side Door Window Upper Reveal Molding Rivets (Qty: 6)
WARNING:

Refer to Glass and Sheet Metal Handling Warning.

Procedure

  1. Lower the window to the fully down position.
  2. When drilling cover/protect the interior trim and door from the metal shavings.
  3. The rivets are located in the inner upper door frame.
  4. Use a suitable tool, drill out the rivets from around the upper door frame.
4 Rear Side Door Window Upper Reveal Molding
Procedure 
Use a suitable tool, install the rivets in the upper door frame.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.