Digital Radio Receiver Replacement

2011 Buick Enclave CXL, FWDSECTION Digital Radio Receiver Replacement
Fig 1: Identifying Digital Radio Receiver
GM1847590Courtesy of GENERAL MOTORS CORP.
Digital Radio Receiver Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the left rear quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Acadia with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB5) , Quarter Lower Rear Trim Panel Replacement (Acadia with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB4) .
  2. Remove the liftgate close actuator bracket (if equipped). Refer to Liftgate Close Actuator Bracket Replacement .
1 Communication Interface Module Bracket
Procedure 
Disconnect the electrical connectors.
2 Digital Radio Receiver
Procedure 
Refer to Control Module References for programming and set up information.
TIP:  Pull tab to release the receiver.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.