SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2011ENCLAVE CXL, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION SYSTEM - PARK ASSIST SYSTEMREPAIR INSTRUCTIONSREAR OBJECT ALARM CONTROL MODULE REPLACEMENT
2011 Buick Enclave CXL, FWD

Rear Object Alarm Control Module Replacement

2011 Buick Enclave CXL, FWDSECTION Rear Object Alarm Control Module Replacement
Fig 1: View Of Object Alarm Module & Bracket
GM1847695Courtesy of GENERAL MOTORS CORP.
Rear Object Alarm Control Module Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the left rear quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Acadia with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB5) , Quarter Lower Rear Trim Panel Replacement (Acadia with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB4) .
  2. Remove the liftgate actuator (if equipped). Refer to Liftgate Actuator Replacement .
1 Communication Interface Module Bracket

Procedure

  1. Disconnect the body harness from the bracket as required.
  2. Loosen the bracket fasteners to remove the bracket from the slotted holes.
  3. Disconnect the electrical connectors.
2 Rear Object Alarm Module
Procedure 
Refer to Control Module References Control Module References for programming and set up.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.