SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 320 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ENGINE CONTROL MODULE X2 THROUGH PRESSURE CONTROL SOLENOID)COMPONENT CONNECTOR END VIEWSMEMORY SEAT MODULE (MSM) X7 (A45/AM3/KB6)
2010 Buick Lucerne CXL, 3.9 1

Memory Seat Module (MSM) X7 (A45/AM3/KB6)

2010 Buick Lucerne CXL, 3.9 1SECTION Memory Seat Module (MSM) X7 (A45/AM3/KB6)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Memory Seat Module (MSM) X7 (A45/AM3/KB6) Connector End View
GM1664553Courtesy of GENERAL MOTORS COMPANY
Memory Seat Module (MSM) X7 (A45/AM3/KB6)

Pin Wire Circuit Function
1-6 - - Not Used
7 0.35 D-GN/WH 1518 Front Vertical Up Switch Signal
8 0.35 YE 1519 Rear Vertical Up Switch Signal
9 0.35 TN 1522 Horizontal Forward Switch Signal
10 0.35 L-GN/YE 276 Recline Motor Forward Switch Signal
11-14 - - Not Used
15 0.35 OG/BK 6604 Driver Seat Massage Switch Signal (AM3)
16 0.35 D-GN 5060 Low Speed GMLAN Serial Data
17 0.35 D-BU 1528 Front Vertical Down Switch Signal
18 0.35 L-BU/BK 1521 Rear Vertical Down Switch Signal
19 0.35 L-GN/BK 1523 Horizontal Rearward Switch Signal
20 0.35 L-BU/YE 277 Recline Motor Rearward Switch Signal
Connector Part Information
  • Harness Type: Left Front Seat
  • OEM Connector: 31410-1202
  • Service Connector: 15126709
  • Description: 20-Way F 64 Series, Sealed (BN)
Terminal Part Information
  • Terminated Lead: 13575845
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.