SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 320 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ENGINE CONTROL MODULE X2 THROUGH PRESSURE CONTROL SOLENOID)COMPONENT CONNECTOR END VIEWSMEMORY SEAT MODULE (MSM) X1 (A45/AM3/KB6)
2010 Buick Lucerne CXL, 3.9 1

Memory Seat Module (MSM) X1 (A45/AM3/KB6)

2010 Buick Lucerne CXL, 3.9 1SECTION Memory Seat Module (MSM) X1 (A45/AM3/KB6)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Memory Seat Module (MSM) X1 (A45/AM3/KB6) Connector End Views
GM1653404Courtesy of GENERAL MOTORS COMPANY
Memory Seat Module (MSM) X1 (A45/AM3/KB6)

Pin Wire Circuit Function
1-6 - - Not Used
7 1 TN/D-BU 2110 Steering Column Telescope Motor Control - Reverse
8 1 OG/D-GN 2098 Steering Column Telescope Motor Control - Forward
9 1 TN 285 Driver Power Seat Horizontal Motor Forward Control
10 1 L-GN 284 Driver Power Seat Horizontal Motor Rearward Control
11 - - Not Used
12 1 D-GN 286 Driver Power Seat Front Vertical Motor Up Control
13 1 D-BU 287 Driver Power Seat Front Vertical Motor Down Control
14 - - Not Used
15 1 YE 282 Driver Power Seat Rear Vertical Motor Up Control
16 1 L-BU 283 Driver Power Seat Rear Vertical Motor Down Control
Connector Part Information
  • Harness Type: Left Front Seat
  • OEM Connector: 6098-4611
  • Service Connector: 15134091
  • Description: 16-Way F 1.5 Series (BK)
Terminal Part Information
  • Terminated Lead: 13575580
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-2A (GY)
  • Terminal/Tray: 8240-0128/22
  • Core/Insulation Crimp: C/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.