SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 320 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ENGINE CONTROL MODULE X2 THROUGH PRESSURE CONTROL SOLENOID)COMPONENT CONNECTOR END VIEWSLUMBAR ADJUSTER SWITCH - PASSENGER (AL2)
2010 Buick Lucerne CXL, 3.9 1

Lumbar Adjuster Switch - Passenger (AL2)

2010 Buick Lucerne CXL, 3.9 1SECTION Lumbar Adjuster Switch - Passenger (AL2)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Lumbar Adjuster Switch - Passenger (AL2) Connector End View
GM73146Courtesy of GENERAL MOTORS COMPANY
Lumbar Adjuster Switch - Passenger (AL2)

Pin Wire Circuit Function
A 2 OG/PU 792 Passenger Seat Lumbar Down Switch Signal
B 2 D-BU 211 Passenger Seat Lumbar Motor Forward Control
C 2 WH 210 Passenger Seat Lumbar Motor Rearward Control
D - - Not Used
E 0.8 BK 450 Ground
F 2 PK 793 Passenger Seat Lumbar Up Switch Signal
G 0.5 OG/BN 1640 Battery Positive Voltage (A45)
2 TN/D-BU 4240 Battery Positive Voltage (without A45)
Connector Part Information
  • Harness Type: Right Front Seat
  • OEM Connector: 12052854
  • Service Connector: 15862656
  • Description: 7-Way F Metri-Pack 280 Series (BK)
Terminal Part Information
  • Terminated Lead: Pending
  • Release Tool: J-38125-11A
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 12015858/4
  • Core/Insulation Crimp: F/G
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.