SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 320 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ENGINE CONTROL MODULE X2 THROUGH PRESSURE CONTROL SOLENOID)COMPONENT CONNECTOR END VIEWSHEATED STEERING WHEEL MODULE (N30)
2010 Buick Lucerne CXL, 3.9 1

Heated Steering Wheel Module (N30)

2010 Buick Lucerne CXL, 3.9 1SECTION Heated Steering Wheel Module (N30)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Steering Wheel Module (N30) Connector End View
GM901282Courtesy of GENERAL MOTORS COMPANY
Heated Steering Wheel Module (N30)

Pin Wire Circuit Function
1 0.35 BK 350 Ground
2 - - Not Used
3 0.35 BK/WH 5883 Heated Steering Wheel Switch LED Control
4 1 RD 41 Ignition 3 Voltage
5 0.35 GY 5886 Heated Steering Wheel Sensor Signal
6 0.35 RD/WH 5884 Heated Steering Wheel High Control
7 0.35 YE 5888 Heated Steering Wheel Switch Signal
8 - - Not Used
Connector Part Information
  • Harness Type: Steering Wheel
  • OEM Connector: 15327190
  • Service Connector: 88988407
  • Description: 8-Way F DUCON 0.8 Series (BK)
Terminal Part Information
  • Terminated Lead: Service by Harness - See Part Catalog
  • Release Tool: Not Available
  • Diagnostic Test Probe: Not Available
  • Terminal/Tray: Not Available
  • Core/Insulation Crimp: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.