SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 320 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ENGINE CONTROL MODULE X2 THROUGH PRESSURE CONTROL SOLENOID)COMPONENT CONNECTOR END VIEWSHEATED SEAT SWITCH - RIGHT REAR (KA6)
2010 Buick Lucerne CXL, 3.9 1

Heated Seat Switch - Right Rear (KA6)

2010 Buick Lucerne CXL, 3.9 1SECTION Heated Seat Switch - Right Rear (KA6)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Seat Switch - Right Rear (KA6) Connector End View
GM646388Courtesy of GENERAL MOTORS COMPANY
Heated Seat Switch - Right Rear (KA6)

Pin Wire Circuit Function
A 0.35 PK/BK 6595 Right Rear Heated Seat Back Only Mode Switch Signal
B 0.35 L-BU/BN 6589 Right Rear Heated Seat Back Only Mode Indicator Control
C 0.35 PK/YE 1631 Heated Seat Low Indicator Control
D 0.35 BN/WH 6585 Heated Seat Medium Indicator Control
E 0.35 TN/WH 1638 Heated Seat High Indicator Control
F 0.35 GY 8 Instrument Panel Lamp Supply Voltage
G 0.35 PU/WH 6597 Right Rear Heated Seat Back Cushion Switch Signal
H 0.35 L-GN 6591 Right Rear Heated Seat Heat Back Cushion Indicator Control
J 0.35 BK 750 Ground
K 0.35 PU 1382 LED Dimming Signal
Connector Part Information
  • Harness Type: Right Rear Door Trim
  • OEM Connector: 15332158
  • Service Connector: 19153745
  • Description: 10-Way M GT 150 Series (BK)
Terminal Part Information
  • Terminated Lead: Pending
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-3 (GY)
  • Terminal/Tray: 15304702/19
  • Core/Insulation Crimp: E/C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.