SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 320 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ENGINE CONTROL MODULE X2 THROUGH PRESSURE CONTROL SOLENOID)COMPONENT CONNECTOR END VIEWSHEATED SEAT MODULE - REAR X1 (KA6)
2010 Buick Lucerne CXL, 3.9 1

Heated Seat Module - Rear X1 (KA6)

2010 Buick Lucerne CXL, 3.9 1SECTION Heated Seat Module - Rear X1 (KA6)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Seat Module - Rear X1 (KA6) Connector End View
GM1664577Courtesy of GENERAL MOTORS COMPANY
Heated Seat Module - Rear X1 (KA6)

Pin Wire Circuit Function
1 0.8 BK/WH 2432 Left Heated Seat Back Element Control
2 0.8 D-GN 2296 Right Heated Seat Cushion Element Control
3 0.8 BN 2295 Left Heated Seat Element Supply Voltage
4 0.8 TN 2481 Right Heated Seat Back Element Control
5 0.8 GY 2294 Left Seat Cushion Element Control
6 0.8 BN/WH 2297 Right Heated Seat Element Supply Voltage
Connector Part Information
  • Harness Type: Rear Seat
  • OEM Connector: 6098-4606
  • Service Connector: Service by Harness- See Part Catalog
  • Description: 6-Way F (BN)
Terminal Part Information
  • Terminated Lead: Pending
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-35 (VT)
  • Terminal/Tray: 8100-4444/22
  • Core/Insulation Crimp: 2/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.