SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 320 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ENGINE CONTROL MODULE X2 THROUGH PRESSURE CONTROL SOLENOID)COMPONENT CONNECTOR END VIEWSHEATED SEAT ELEMENT - LEFT REAR BACK (KA6)
2010 Buick Lucerne CXL, 3.9 1

Heated Seat Element - Left Rear Back (KA6)

2010 Buick Lucerne CXL, 3.9 1SECTION Heated Seat Element - Left Rear Back (KA6)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Seat Element - Left Rear Back (KA6) Connector End View
GM40399Courtesy of GENERAL MOTORS COMPANY
Heated Seat Element- Left Rear Back (KA6)

Pin Wire Circuit Function
A 0.8 BN 2295 Left Heated Seat Element Supply Voltage
B 0.8 BK/WH 2432 Left Heated Seat Back Element Control
C 0.35 L-GN 7045 Left Rear Heated Seat Back Temperature Sensor Signal
D 0.35 L-GN/WH 7046 Left Rear Heated Seat Back Temperature Sensor Low Reference
Connector Part Information
  • Harness Type: Rear Seat
  • OEM Connector: 12064761
  • Service Connector: Service by Harness- See Part Catalog
  • Description: 4-Way M Metri-Pack 150 Series (BK)
Terminal Part Information
  • Pins: A, B
  • Terminated Lead: 13505668
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-3 (GY)
  • Terminal/Tray: 12047581/2
  • Core/Insulation Crimp: E/A
  • Pins: C, D
  • Terminated Lead: 13575462
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-3 (GY)
  • Terminal/Tray: 12047581/2
  • Core/Insulation Crimp: E/C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.