SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 314 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - 1-2 SHIFT SOLENOID THROUGH ENGINE CONTROL MODULE X1)COMPONENT CONNECTOR END VIEWSDOOR LOCK/ WINDOW SWITCH - PASSENGER X4 (KB6)
2010 Buick Lucerne CXL, 3.9 1

Door Lock/ Window Switch - Passenger X4 (KB6)

2010 Buick Lucerne CXL, 3.9 1SECTION Door Lock/ Window Switch - Passenger X4 (KB6)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Lock/ Window Switch - Passenger X4 (KB6) Connector End View
GM1664522Courtesy of GENERAL MOTORS COMPANY
Door Lock/ Window Switch - Passenger X4 (KB6)

Pin Wire Circuit Function
1 0.35 WH/BK - Front Passenger Heated Seat Medium Indicator Control
2 0.35 D-GN/BK - Front Passenger Heated Seat High Indicator Control
3 0.35 L-GN/BK - Front Passenger Heated Seat Cool Switch Signal
4 0.35 BK/WH - Front Passenger Heated Seat Switch Low Reference
5 - - Not Used
6 0.35 BK - Front Passenger Heated Seat Back Cushion Switch Signal
7 0.35 GY - Front Passenger Heated Seat Back Only Mode Switch Signal
8 - - Not Used
9 0.35 D-BU - Front Passenger Heated Seat Switch Lamp Dimming
10 0.35 BN - Front Passenger Heated Seat Cool Indicator Control
11 0.35 PU - Front Passenger Heated Seat Back Only Mode Indicator Control
12 0.35 OG/WH - Front Passenger Heated Seat Back Cushion Indicator Control
13 0.35 BN/WH - Front Passenger Heated Seat Low Indicator Control
14 - - Not Used
Connector Part Information
  • Harness Type: Right Front Door Trim
  • OEM Connector: 7283-9065-40
  • Service Connector: 15127039
  • Description: 14-Way F (L-GY)
Terminal Part Information
  • Terminated Lead: Service by Harness - See Part Catalog
  • Release Tool: Not Available
  • Diagnostic Test Probe: Not Available
  • Terminal/Tray: Not Available
  • Core/Insulation Crimp: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.