SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 314 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - 1-2 SHIFT SOLENOID THROUGH ENGINE CONTROL MODULE X1)COMPONENT CONNECTOR END VIEWSDOOR LOCK/ WINDOW SWITCH - DRIVER X7
2010 Buick Lucerne CXL, 3.9 1

Door Lock/ Window Switch - Driver X7

2010 Buick Lucerne CXL, 3.9 1SECTION Door Lock/ Window Switch - Driver X7
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Lock/ Window Switch - Driver X7 Connector End View
GM1664543Courtesy of GENERAL MOTORS COMPANY
Door Lock/ Window Switch - Driver X7

Pin Wire Circuit Function
1 0.35 YE 190 Folding Mirror Motor Extend Control (DL3)
2 0.35 L-BU 191 Folding Mirror Motor Retract Control (DL3)
3 - - Not Used
4 0.35 D-GN/TN 784 Driver Mirror Vertical Position Sensor Signal (A45)
5 0.35 GY/PU 786 Driver Mirror Horizontal Position Sensor Signal (A45)
6 - - Not Used
7 0.35 D-BU 672 5-Volt Reference (A45)
8 0.35 PK 5853 LED Signal (UFT)
9 - - Not Used
10 0.35 BN/L-GN 673 Low Reference (A45)
Connector Part Information
  • Harness Type: Left Front Door Trim
  • OEM Connector: 7283-9045
  • Service Connector: 15127040
  • Description: 10-Way F 0.64 Series (WH)
Terminal Part Information
  • Terminated Lead: 13575845
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.