SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2010LUCERNE CXL, 3.9 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 314 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - 1-2 SHIFT SOLENOID THROUGH ENGINE CONTROL MODULE X1)COMPONENT CONNECTOR END VIEWSDISTANCE SENSING CRUISE CONTROL MODULE (K59)
2010 Buick Lucerne CXL, 3.9 1

Distance Sensing Cruise Control Module (K59)

2010 Buick Lucerne CXL, 3.9 1SECTION Distance Sensing Cruise Control Module (K59)
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Distance Sensing Cruise Control Module (K59) Connector End View
GM831393Courtesy of GENERAL MOTORS COMPANY
Distance Sensing Cruise Control Module (K59)

Pin Wire Circuit Function
1 0.35 RD/GN 1040 Battery Positive Voltage
2 - - Not Used
3 0.35 YE 5727 High Speed GMLAN Serial Data Wake Up
4 0.35 BN/BK 2500 High Speed GMLAN Serial Data Bus +
5 0.35 BN 2501 High Speed GMLAN Serial Data Bus -
6 0.35 BK 250 Ground
Connector Part Information
  • Harness Type: Forward Lamp
  • OEM Connector: 2-967616-1
  • Service Connector: 88953345
  • Description: 6-Way F 0.64 MQS Series, Sealed (GY)
Terminal Part Information
  • Terminated Lead: 13576394
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: 962885-5/15
  • Core/Insulation Crimp: 6/6
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.