Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2007RAINIER AWD L6-4.2LREPAIR AND DIAGNOSISSTARTING AND CHARGINGTECHNICAL SERVICE BULLETINS
2007 Buick Rainier AWD L6-4.2L
Starting and Charging: Technical Service Bulletins
2007 Buick Rainier AWD L6-4.2LSECTION Technical Service Bulletins
- Recalls
- Customer Interest
- Starting System - Engine No Start/No Crank Condition
- A/T - Key Will Not Release From Ignition Lock Cylinder
- Instruments - Erratic Speedometer Operation
- Brakes - ABS Lamp ON/DTC's C0265/C0201/U1041 Set
- Audio System - Noise When Using OnStar(R)
- Electrical - Intermittent MIL/DTC P2138/Reduced Power
- Electrical - MIL ON/DTC's Set By Various Control Modules
- By Symptom
- Abnormal wear/deterioration
- Customer Interest
- Starting System - Engine No Start/No Crank Condition
- A/T - Key Will Not Release From Ignition Lock Cylinder
- Instruments - Erratic Speedometer Operation
- Brakes - ABS Lamp ON/DTC's C0265/C0201/U1041 Set
- Audio System - Noise When Using OnStar(R)
- Electrical - Intermittent MIL/DTC P2138/Reduced Power
- Electrical - MIL ON/DTC's Set By Various Control Modules
- Erratic Operation
- Loose
- Noise
- Recalls
- Starting problems
- All Technical Service Bulletins
- Charging System - Low Voltage Display/Battery Discharged
- Starting System - Engine No Start/No Crank Condition
- Electrical - Instrument Panel And General Wiring Repair
- Battery - Diagnosis and Charging
- Electrical - Proper Jump Starting Procedure
- Electrical - Aftermarket Fuse Warning
- Starting System - Starter Cranks After Key Released
- A/T - Key Will Not Release From Ignition Lock Cylinder
- A/C - Battery Draw Information
- Instruments - Erratic Speedometer Operation
- Electrical - GM-Approved Terminal Probe Test Kit
- Electrical - Battery Charging Tips/Recommendations
- Battery/Charging System - Electrical Diagnostics Info.
- Remote Starting System - System Inoperative Diagnostics
- Electrical - Reducing Intermittent Electrical Concerns
- Brakes - ABS Lamp ON/DTC's C0265/C0201/U1041 Set
- Audio System - Noise When Using OnStar(R)
- Electrical - Intermittent MIL/DTC P2138/Reduced Power
- Electrical - MIL ON/DTC's Set By Various Control Modules
- Recall 12V406000: Driver's Door Module Corrosion
- Locks - Key Code Security Rules, Key Code Look Up
- Electrical - Aftermarket Interface Devices Causing Issues
- Electrical - Ground Repair Information
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.