Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Change Engine Oil Indicator Always On
2007 Buick Rainier AWD L6-4.2LSECTION Change Engine Oil Indicator Always On
Change Engine Oil Indicator Always On
Diagnostic Fault Information
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
Circuit/System Description
The engine control module (ECM)/powertrain control module (PCM) determines when the engine oil should be changed and calculates the oil life in percent. The ECM/PCM sends this information via class 2 serial data to the instrument panel cluster (IPC) which illuminates the oil level percent in the driver information center (DIC). The IPC will illuminate the CHANGE ENGINE OIL message and indicator when the oil needs to be changed.
Circuit/System Verification
1. Verify the scan tool Engine Oil Life Remaining parameter is greater than 0 percent.
• If equal to 0 percent, reset the engine oil life.
2. If the percent value is normal, replace the IPC.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests
* GM Oil Life System Resetting
* Control Module References for IPC replacement, setup, and programming
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.