Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet)
2007 Buick Rainier AWD L6-4.2LSECTION Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet)
Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet)
Removal Procedure
1. Tilt the steering wheel to the full down position.
2. Remove the left closeout/insulator panel.
3. Remove the knee bolster trim panel.
4. Remove the screws retaining the bezel to the instrument panel.
5. Remove the bezel from the instrument panel.
6. If equipped, remove the transfer case shift control switch.
7. Remove the rear wiper washer switch.
8. If equipped, remove the cigar lighter or 12-volt power supply outlets.
9. Remove the bezel from the vehicle.
Installation Procedure
1. If equipped, install the cigar lighter or 12-volt power supply outlets.
2. Install the rear wiper washer switch.
3. If equipped, install the transfer case shift control switch.
4. Install the bezel to the instrument panel.
Notice: Refer to Fastener Notice.
5. Install the screws retaining the bezel to the instrument panel.
Tighten the screws to 2.5 N.m (22 lb in).
6. Install the knee bolster trim panel.
7. Install the left closeout/insulator panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.