Assist Handle Replacement - Front

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Assist Handle Replacement - Front
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Assist Handle Screws
GM1538918Courtesy of GENERAL MOTORS CORP.
Assist Handle Replacement - Front

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .
1 Roof Rail Front Assist Handle Screws (Qty: 2)
Tip:Β  Use a small flat bladed tool to lift up the plastic cover to expose the screws.

Tighten:Β  9 N.m (80 lb in)

2 Roof Rail Front Assist Handle
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.