Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the end cap on the side of the instrument panel (I/P).
  2. Pull out to remove the tweeter speaker wire clip from the I/P.
  3. Disconnect the speaker wire from the I/P electrical harness.
  4. Remove the windshield garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
  5. Fig 1: Front Windshield Pillar Speaker
    GM758477Courtesy of GENERAL MOTORS CORP.
  6. Pull the speaker wire up through the I/P.
  7. Remove the speaker from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.