SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 84 (CELLULAR COMMUNICATION SYSTEMS)REPAIR INSTRUCTIONSNAVIGATION ANTENNA REPLACEMENTINSTALLATION PROCEDURE
2006 Buick Terraza CXL, 3.5 L, AWD

Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coaxial Cable Navigation Antenna
    GM1204254Courtesy of GENERAL MOTORS CORP.
  1. Clean the surface of the rear shelf in the navigation antenna mounting location, using an isopropyl alcohol pad and a clean lint-free cloth.
    2. IMPORTANT: Do not touch the adhesive backing.
  2. Remove the protective backing from the adhesive of the navigation antenna.
  3. Install the navigation antenna (2) to the rear shelf surface.

    Press the navigation antenna into place for approximately 30 seconds until fully seated.

  4. Connect the navigation antenna cable connector.
  5. Install the sound barrier.
  6. Install the rear shelf trim panel. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.