Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Communication Interface Module
    GM1230652Courtesy of GENERAL MOTORS CORP.
  1. Route the antenna extension cable. Secure the cable.
  2. Connect the antenna extension cable to the communication interface module.
  3. Install the left I/P insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
  4. Fig 2: View Of Antenna Extension Cable
    GM1204334Courtesy of GENERAL MOTORS CORP.
  5. Connect the antenna extension cable from the module to the antenna cable.
  6. Fig 3: View Of Left Instrument Panel Outer Trim Cover
    GM929251Courtesy of GENERAL MOTORS CORP.
  7. Install the left I/P outer trim cover.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.