SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (ANTILOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)REPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE (BPMV) BRACKET REPLACEMENTINSTALLATION PROCEDURE
2006 Buick Terraza CXL, 3.5 L, AWD

Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of BPMV Bracket Nuts
    GM230411Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV bracket (4) to the wheel house.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 3 BPMV bracket nuts (1, 2, 3) to the studs on the BPMV bracket (4).

    Tighten:  Tighten the 3 BPMV bracket nuts to 10 N.m (7 lb ft).

  3. Install the BPMV and EBCM as an assembly to the BPMV bracket. Refer to Brake Pressure Modulator Valve (BPMV) Replacement .
  4. Turn the ignition switch to the RUN position.
  5. Perform the Diagnostic Trouble Code (DTC) List - Vehicle .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.