Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary WindowsΒ .
  2. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  3. Install the windshield wipers arms and blades. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
  4. Install the windshield garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
  5. Install the rearview mirror. Refer to Rearview Mirror ReplacementΒ .
  6. Connect the rain senor connector, if equipped.
  7. Connect the diversity antenna, if equipped.
  8. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  9. Close the hood.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.