Wiper Motor, Wiper System Module Replacement

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Wiper Motor, Wiper System Module Replacement
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Wiper Arm, Blade & Insert - Front
GM1536832Courtesy of GENERAL MOTORS CORP.
Wiper Motor, Wiper System Module Replacement

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
Wiper System Module Replacement 

Preliminary Procedures

  1. Remove the wiper arms. Refer to Wiper Arm, Blade, Insert Replacement - Front .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
1 Bolt, Wiper System Module (Qty: 3)

Tighten:  10 N.m (89 lb in)

2 Nut, Wiper System Module (Qty: 1)

Tighten:  10 N.m (89 lb in)

3 Nut, Wiper Motor (Qty: 3)

Tighten:  10 N.m (89 lb in)

4 Wiper Drive System Module
5 Wiper Motor
Tip:  Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.