SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 35 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWASHER SOLVENT CONTAINER LEVEL SENSOR REPLACEMENTREMOVAL PROCEDURE
2006 Buick Terraza CXL, 3.5 L, AWD

Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the washer solvent from the washer solvent container.
  2. Remove the right front fender liner. Refer to Fender, Fender Insulator, Wheelhouse Liner Replacement - Front in Body Front End.
    3. Fig 1: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the washer solvent container level sensor electrical connector.
  4. Using a small flat-bladed tool, remove the washer solvent level sensor from the washer solvent container.
  5. Using a small flat-bladed tool, remove the seal from the washer solvent container.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.