Diagnostic Code Index

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Diagnostic Code Index
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX

DTC Description
DTC P0010 or P0011 Camshaft Position (CMP) Actuator Solenoid Control Circuit & System Performance
DTC P0016 Crankshaft Position (CKP) Camshaft Position (CMP) Correlation
DTC P0030, P0036, P0053, P0054, P0135, or P0141 HO2S Heater Control Circuit Sensor 1 & 2, Resistance Sensor 1 & 2, and Performance Sensor 1 & 2
DTC P0068 or P0121 Throttle Body Airflow Performance & Throttle Position (TP) Sensor Performance
DTC P0101 or P1101 Mass Air Flow (MAF) Sensor Performance & Intake Air Flow System Performance
DTC P0102 or P0103 Mass Air Flow (MAF) Sensor Circuit Low & High Frequency
DTC P0106 Manifold Absolute Pressure (MAP) Sensor Performance
DTC P0107 or P0108 Manifold Absolute Pressure (MAP) Sensor Circuit Low & High Voltage
DTC P0112 or P0113 Intake Air Temperature (IAT) Sensor Circuit Low & High Voltage
DTC P0116 Engine Coolant Temperature (ECT) Sensor Performance
DTC P0117 or P0118 Engine Coolant Temperature (ECT) Sensor Circuit Low & High Voltage
DTC P0120, P0122, P0123, P0220, P0222, P0223, or P2135 Throttle Position (TP) Sensor 1 & 2 Circuits Low & High Voltage
DTC P0128 Engine Coolant Temperature (ECT) Below Thermostat Regulations Temperature
DTC P0131, P0132, P0137, or P0138 HO2S Circuit Low & High Voltage Sensors 1 & 2
DTC P0133, P0134, P0140, P1133, P2A00 or P2A01 HO2S Circuit & Sensor Performance
DTC P0171 or P0172 Fuel Trim System Lean & Rich
DTC P0201, P0202, P0203, P0204, P0205, or P0206 Injector 1 - 6 Control Circuit
DTC P0230 Fuel Pump Relay Control Circuit
DTC P0300 Engine Misfire Detected
DTC P0315 Crankshaft Position (CKP) System Variation Not Learned
DTC P0324, P0325, P0326, P0327, P0328, P0330, P0332, or P0333 Knock Sensor (KS) Module Performance
DTC P0335 or P0336 Crankshaft Position (CKP) Sensor Circuit & Performance
DTC P0340 or P0341 Camshaft Position (CMP) Sensor Circuit & Performance
DTC P0351, P0352, or P0353 Ignition Coil 1 - 3 Control Circuit
DTC P0411 Secondary Air Injection (AIR) System Insufficient Air Flow Detected
DTC P0412 or P0418 Secondary Air Injection (AIR) Solenoid Relay Control & Pump Control Circuit
DTC P0420 Catalyst System Low Efficiency Bank 1
DTC P0442 Evaporative Emissions (EVAP) System Small Leak Detected
DTC P0443 or P0449 Evaporative Emission (EVAP) Purge & Vent Solenoid Control Circuits
DTC P0446 Evaporative Emissions (EVAP) Vent System Performance
DTC P0451, P0452, P0453, or P0454 Fuel Tank Pressure (FTP) Sensor Performance
DTC P0455 Evaporative Emission (EVAP) System Large Leak
DTC P0496 Evaporative Emission System Flow During Non-Purge
DTC P0506 or P0507 Idle Speed Low & High
DTC P0601, P0602, P0603, P0604, P0606, P0607, P060D, P062F, or P2610 Control Module Performance
DTC P0641 or P0651 5-Volt Reference 1 & 2 Circuits
DTC P0650 Malfunction Indicator Lamp (MIL) Control Circuit
DTC P0685, P0689, or P0690 Engine Controls Ignition Relay Control Circuit & Relay Feedback Circuit Low Voltage
DTC P0700 Transmission Control Module (TCM) Requested MIL Illumination
DTC P1174 Air Fuel Imbalance Bank 1
DTC P1400 Cold Start Emission Reduction Control System
DTC P1516, P2101, P2119, or P2176 Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance
DTC P1682 Ignition 1 Switch Circuit 2
DTC P2120, P2122, P2123, P2125, P2127, P2128, or P2138 Accelerator Pedal Position (APP) Sensors 1 & 2 Circuit Low & High Voltage & Sensors 1-2 Correlation
DTC P2440 Secondary Air Injection (AIR) Valve Stuck Open
DTC P2444 Secondary Air Injection (AIR) System Pump Stuck On
DTC P2430, P2431, P2432, or P2433 Secondary Air Injection (AIR) System Pressure Sensor Stuck in Range, Sensor Performance & Sensor Circuit Low & High Voltage
DTC P2544 Transmission Torque Request Circuit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.