Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 267 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSENGINE OIL COOLER HOSE/PIPE REPLACEMENTINSTALLATION PROCEDURE

2006 Buick Terraza CXL, 3.5 L, AWD

Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Install the engine oil cooler lines to the vehicle.
Install the engine oil cooler lines to the engine oil cooler. Refer to Engine Oil Cooler Pipe/Hose Quick Connect Fitting .

Fig 1: View Of Engine Oil Cooler Lines
Courtesy of GENERAL MOTORS CORP.
Install the engine oil cooler lines to the engine oil filter adapter. Refer to Engine Oil Cooler Pipe/Hose Quick Connect Fitting .
Install the engine oil cooler line support clip to the engine oil cooler lines.
Install the right engine splash shield. Refer to Splash Shield Replacement - Engine (Right) or Splash Shield Replacement - Engine (Left) .
Install the lower air baffle. Refer to Radiator Air Lower Baffle and Deflector Replacement .
Add the proper amount of engine oil.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.