Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Install the engine mount struts.
- Install the engine mount strut to engine mount strut bracket bolts/nuts.
- On the right side, ensure that the engine harness clamp is sandwiched between the bolt (4) and the strut bracket.
- Tighten the engine mount strut to engine mount strut bracket bolts/nuts.
Tighten: Tighten the bolts/nuts to 50 N.m (37 lb ft).
- Install the engine mount strut to radiator support bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.