Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 261 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Buick Terraza CXL, 3.5 L, AWD
Fastener Tightening Specifications
2006 Buick Terraza CXL, 3.5 L, AWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Battery Hold Down Bolt (RPOs LZE/LZ9) | 18 N.m | 13 lb ft |
| Battery Retainer Bolt (LS4) | 18 N.m | 13 lb ft |
| Battery Tray Bolt | 5 N.m | 44 lb in |
| Generator Bolt/Stud | 50 N.m | 37 lb ft |
| Generator Bracket Bolt (RPO LS4) | 50 N.m | 37 lb ft |
| Generator Output BAT Terminal Nut | 30 N.m | 22 lb ft |
| Ground Wire Bolt | 10 N.m | 89 lb in |
| Negative Battery Cable Terminal Nut | 15 N.m | 11 lb ft |
| Positive Battery Cable Junction Block Lead Nut | 10 N.m | 89 lb in |
| Positive Battery Cable Terminal Nut | 15 N.m | 11 lb ft |
| Starter Bolt | 43 N.m | 32 lb ft |
| Starter Solenoid "BAT" Terminal Nut | 10 N.m | 89 lb in |
| Transaxle Stud Nut | 30 N.m | 22 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.