SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 221 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSREAR BRAKE PADS REPLACEMENTREMOVAL PROCEDURE
2006 Buick Terraza CXL, 3.5 L, AWD

Removal Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Brake Dust Caution in Cautions and Notices.
  1. Inspect the fluid level in the brake master cylinder reservoir.
  2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, then no brake fluid needs to be removed from the reservoir before proceeding. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, then remove brake fluid to the midway point before proceeding.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the rear tire and the wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Install a hand tightened lug nut to retain the rotor to the hub.
    6. Fig 1: Pushing In Brake Caliper Piston
    GM176947Courtesy of GENERAL MOTORS CORP.
  6. Compress the caliper piston enough for clearance. Use a C-clamp (3).
    7. Fig 2: View Of Upper Caliper Bolt - Rear
    GM176946Courtesy of GENERAL MOTORS CORP.
  7. Remove the upper caliper bolt (2).
    NOTE: Use care to avoid damaging pin boot when rotating caliper.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.